To see more, visit my blog: I was no artist back then, but i remembered that a college roommate once bent a cafeteria fork into a rough bracelet. First, bend two of the tines a bit down like on the picture.
Apply Pressure To Bend And Curve The Front Portion Of The Fork (With The Tines) Downward.
Making bracelets, coat hooks, drawer handles or windchimes out of flatware requires drilling a hole in each piece, typically in the handle. How to make a fork bracelet ~. Here are the two tools i demonstrate in the video:
Then, Bend The Internal Ones Laterally, Keeping An Angle Of About 30 Degrees Between Them.
Then bend the tines in the shape. I can anneal and then wait a few. Slightly bend fork to make a smooth curve which can fit for wrist and then further bend it into bracelet shape.
Once Cooled, The Metal Is Easier To Bend And Less Likely To Break Than Before.
I buff and polish the sections with my full size bench grinder that have buffing/polishing wheels attached, or i also use a dremel flex shaft with the felt buffing wheels. You must hold the glass tight because if it slips, it might harm you. Patreon.com/jamesfaberhere are some of the tools i use:dremel rotary tools:
Making Bracelets, Coat Hooks, Drawer Handles Or Windchimes Out Of Flatware Requires Drilling A Hole In Each Piece, Typically In The Handle.
To do that, heat the tines of the fork and bend the center two outward like petals. Bracelet bending pliers — eurotool is the brand i use. Here is another one from cut out and keep :
